Sony BVM-1915
- Sony BVM-1915, BVM-2015P, BVM-2015PM Service Manual
- Sony Technical Bulletin 2001-222: Part Registration - Power Thermistor
- Sony Technical Bulletin 2003-144: Reuse IC1 When Replacing GA Board
- Sony Technical Bulletin 2005-008: Parts Registration - Handle Assembly
- Sony Technical Bulletin 2005-059: Reuse Parts When Replacing EB or EC Board on EA Board
- Sony Technical Bulletin 2005-083: Reuse Parts When Replacing BK Board
- Sony Technical Bulletin 2005-145: Reuse B Board Shield When Replacing BH Board
- Sony Technical Bulletin 92-064: Uneven Color in Component Mode
- Sony Technical Bulletin 92-078: Correction of Interrupted Circuit
- Sony Technical Bulletin 93-237: Correcting Picture Shading
- Sony Technical Bulletin 93-284: Firmware Update 1.02
- Sony Technical Bulletin 94-007: Correcting Flicker and Smear
- Sony Technical Bulletin 94-025: Bounced Brightness When 100IRE Full-White Signal is Switched to 20 IRE
- Sony Technical Bulletin 94-228: Electrolytic Capacitor Replacement - GA Board
- Sony Technical Bulletin 94-239: Part Numbers for BVM Series Rear Covers
- Sony Technical Bulletin 94-244: Part Registration - Bottom Plate Assembly
- Sony Technical Bulletin 98-236: Enhanced Electrolytic Capacitors on EA Board
- Sony Technical Bulletin 98-270: EA Board Enhanced Reliability
Photos
The Sony BVM-1915 is a 19-inch broadcast video monitor (BVM) produced by Sony, designed for the NTSC market. It features an HR Trinitron CRT with 800 lines of horizontal resolution, making it a Grade 1 reference monitor suitable for critical color evaluation and broadcast quality control. The PAL equivalents of this model are the BVM-2015P and BVM-2015PM, which share the same service manual.[1]
The BVM-1915 belongs to an earlier generation of Sony's BVM line, produced around 1990.[2] Unlike later BVM models such as the BVM-20E1U and BVM-20F1U — which adopted a modular design requiring a separate BKM-10R or BKM-11R control unit — the BVM-1915 features built-in controls housed in a pull-out drawer on the front of the unit, offering extensive adjustment options directly on the monitor itself.[3] This design is similar to the older BVM-1910/2010 generation, which also integrated the controller into the monitor body.[4]
All BNC inputs on the BVM-1915 are equipped with loop-through outputs. When the loop-through output of any input is not in use, a 75-ohm BNC terminator should be attached to maintain proper signal levels.[2] The RGBS and component (R-Y/B-Y) inputs share the same set of BNC connectors and the user must select between the two modes, as they cannot be used simultaneously.
References
- ↑ Sony BVM-1915 / BVM-2015P / BVM-2015PM Service Manual (Sony Corporation)
- ↑ 2.0 2.1 "Using Sony BVM-1915 without BNC terminators", shmups.system11.org
- ↑ Sony BVM-1915 listing, RGB Mods
- ↑ "SONY BVM CRTs?", Creative COW Forums