Property:Input notes
This is a property of type Text.
S
Three loop-through BNCs at 0.7 Vp-p ±6 dB with sync on green at 0.3 Vp-p negative, or external sync through the EXT SYNC connector. Selected against the component input with the RGB/COMP button. +
1 Vp-p ±6 dB, negative sync. Audio input is −5 dBu into 47 kilohms or higher. Loop-through with automatic 75-ohm termination. +
1 Vp-p ±6 dB, sync negative, automatic 75-ohm termination. Loop-through to LINE B VIDEO OUT / AUDIO OUT. +
Loop-through to the LINE C Y/C OUT and AUDIO OUT. +
Y at 0.7 Vp-p ±6 dB and R-Y / B-Y at 0.7 Vp-p ±6 dB (75% chrominance colour bars) on the same three BNCs as the analog RGB input, selected by the RGB/COMPONENT switch. +
R, G and B at 0.7 Vp-p ±6 dB on three loop-through BNCs shared with the component input; sync on green is 0.3 Vp-p negative, or an external sync generator can be used through EXT SYNC IN. Automatic 75-ohm termination. +
1 Vp-p ±6 dB, sync negative, automatic 75-ohm termination. Audio input is −5 dBu into more than 47 kilohms. Loop-through to LINE A VIDEO OUT / AUDIO OUT. +
1 Vp-p ±6 dB, sync negative, automatic 75-ohm termination. +
R, G and B at 0.7 Vp-p ±6 dB with sync on green at 0.3 Vp-p negative. +
1 Vp-p ±6 dB, sync negative, automatic 75-ohm termination. +
Has its own audio jack and Y/C loop-through output. +
R-Y/Y/B-Y at 0.7 Vp-p ±6 dB on the same BNC trio as RGB. +
Composite sync is fed to the separate EXT SYNC IN BNC at 4 Vp-p ±6 dB, sync negative. +
Has its own AUDIO IN jack and Y/C loop-through output with automatic 75-ohm termination. +
Automatic 75-ohm termination, released when a cable is connected to the VIDEO OUT loop-through. +
Betacam R-Y/Y/B-Y on the same BNC trio as RGB; the front panel selects between RGB and component. +
R/R-Y, G/Y and B/B-Y BNCs at 0.7 Vp-p. With EXT SYNC off the monitor locks to sync on the green channel (0.3 Vp-p, negative). +
Composite sync is supplied on the separate EXT SYNC IN BNC (4 Vp-p, negative) with the EXT SYNC selector on. +
Digital mode, selected by grounding pin 9. Pin 1 further selects IBM RGBI (with luminance on pin 25) or 3-bit TTL. +
Shares the input position with the VTR connector via the S VIDEO/VTR IN selector. Not fitted to all production runs. +
